Results 1 to 3 of 3

Thread: Error 45

  1. #1
    Join Date
    Nov 2014
    Posts
    2
    Rep Power
    1

    Post Error 45

    Hi

    I'm using Quartus II to program a non-volatile security key (.ekp file) into an FPGA. However I keep getting this error message -

    Info: Ended Programmer operation at Mon Nov 17 15:03:01 2014
    Info: Started Programmer operation at Mon Nov 17 15:04:48 2014
    Info: Device 1 contains JTAG ID code 0x020E10DD
    Info: Programming device 1
    Info: Programming the EP2SGX30 device at position 1 for exclusive-secure bitstream configuration
    Error: Unexpected error in JTAG server -- error code 45
    Error: Operation failed
    Info: Ended Programmer operation at Mon Nov 17 15:04:49 2014

    I'm using an Ethernet Blaster II. Does anyone know what error 45 is or what I might be doing?

    Thanks in advance.

  2. #2
    Join Date
    May 2013
    Posts
    1
    Rep Power
    1

    Default Re: Error 45

    Hello,

    I am getting the very same error message : Unexpected error in JTAG server -- error code 45 when trying to program a non-volatile key (.ekp) into a Stratix II.

    The JTAG chain is well detected.
    The Ethernet Blaster II's firmware is up-to-date (April 2016).
    No problem when programming the external flash (.jic)

    Also, programming the .ekp with a former Ethernet Blaster (not II) works flawlessly !

  3. #3
    Join Date
    Nov 2014
    Posts
    2
    Rep Power
    1

    Default Re: Error 45

    Quote Originally Posted by powaq View Post
    Hello,

    I am getting the very same error message : Unexpected error in JTAG server -- error code 45 when trying to program a non-volatile key (.ekp) into a Stratix II.

    The JTAG chain is well detected.
    The Ethernet Blaster II's firmware is up-to-date (April 2016).
    No problem when programming the external flash (.jic)

    Also, programming the .ekp with a former Ethernet Blaster (not II) works flawlessly !
    -----------------------------------------------------------------------------------
    After I posted my original post I did find a solution. It a long time ago but from what I remember, it was due to incompatible programmer firmware & hardware combination. I think I had to reinstall the application as well.

Similar Threads

  1. Replies: 1
    Last Post: March 3rd, 2016, 05:24 AM
  2. modelsim vlog error syntax error, unexpected IDENTIFIER, expecting clocking
    By kito in forum Quartus II and EDA Tools Discussion
    Replies: 1
    Last Post: October 15th, 2014, 11:50 PM
  3. Replies: 6
    Last Post: September 1st, 2014, 08:49 PM
  4. Stratix IV, compile error, CLK error, PLL error
    By integrghb in forum Quartus II and EDA Tools Discussion
    Replies: 0
    Last Post: June 12th, 2012, 11:31 AM
  5. Error: Unexpected error in JTAG server -- error code 35
    By ZioFester in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 1
    Last Post: October 18th, 2011, 11:57 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •