Results 1 to 2 of 2

Thread: DE1 SoC board USB port

  1. #1
    Join Date
    Dec 2014
    Posts
    1
    Rep Power
    1

    Default DE1 SoC board USB port

    Hi. May i know is it possible to give some input signal from a simulator into De1 SoC usb port?If yes, is there any configurations need to be done?If no, may i know if there is any option where can I input the signal from the simulator to the fpga?

  2. #2
    Join Date
    Sep 2016
    Posts
    266
    Rep Power
    1

    Default Re: DE1 SoC board USB port

    The USB on the DE1-SoC is connected to the HPS portion, not the FPGA portion. You can boot into Linux and use applications that interface with the USB to test out your signals.

Similar Threads

  1. do altera produce 100Gb/s fiber port on board or development board?
    By martinboy in forum General Altera Discussion
    Replies: 3
    Last Post: March 21st, 2013, 08:10 PM
  2. How do I get the address of the PHY port on an EP3C120 dev board?
    By gabhades in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 4
    Last Post: February 25th, 2013, 08:40 AM
  3. Reading the serial port on a DE2 Board
    By hanibaal in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 1
    Last Post: February 12th, 2011, 10:44 PM
  4. Max II evalutation board - USB port
    By John Pfaff in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 2
    Last Post: November 17th, 2010, 09:24 AM
  5. how to port nios2 to stratix dsp s80 board?
    By ffone13 in forum General Discussion Forum
    Replies: 3
    Last Post: November 1st, 2004, 01:34 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •