Results 1 to 2 of 2

Thread: MEN F210, Cyclone II and Linux

  1. #1
    Join Date
    May 2018
    Posts
    2
    Rep Power
    1

    Default MEN F210, Cyclone II and Linux

    Hello everybody,
    I'm trying to get data from the GPS of a board, a MEN F210 [1]. The board is installed in an industrial case and I have Debian 9 installed with kernel 4.15. Altera modules of vanilla kernel are compiled and I can see the FPGA being recognized at startup but I can't see the UART device. The FPGA seems in state unknow.

    How do I start the FPGA? I don't have a firmware or anything. I have the MEN tools that should allow me to build the drivers [2] but the software is old and can't make it work (have an Ubuntu 15.04 for that which seems the latest officially supported byt the toolkit).

    Can anyone give me a hint? I'm surely missing something.

    Thanks

    [1] https://www.men.de/products/discontinued-products/f210/
    [2] https://www.men.de/software/13z025-90/

  2. #2
    Join Date
    May 2018
    Posts
    2
    Rep Power
    1

    Default Re: MEN F210, Cyclone II and Linux

    If anyone interested.

    Using kernel 4.16 and some patches that will enter kernel 4.17 I was able to see the UARTs of the board.

Similar Threads

  1. Booting Linux on Cyclone V DE1-SoC
    By jackfrye11 in forum Linux Forum
    Replies: 1
    Last Post: March 13th, 2018, 08:55 PM
  2. run linux in Cyclone II Board
    By alteraashuforum in forum Linux Forum
    Replies: 1
    Last Post: March 4th, 2018, 09:33 PM
  3. Cyclone V SoC Development under Linux (32, 64 BIT)
    By Kiamur in forum Quartus II and EDA Tools Discussion
    Replies: 0
    Last Post: October 10th, 2013, 12:48 AM
  4. Cyclone V (with HPS) Linux Driver
    By c32 in forum Linux Forum
    Replies: 0
    Last Post: July 16th, 2013, 05:08 AM
  5. Cyclone III LS - Linux
    By Jinx in forum Development Kit Related
    Replies: 0
    Last Post: October 8th, 2010, 08:12 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •