Results 1 to 2 of 2

Thread: Which IO standard needs to be used? 200 MHz 1.8 V

  1. #1
    Join Date
    Apr 2018
    Posts
    22
    Rep Power
    1

    Default Which IO standard needs to be used? 200 MHz 1.8 V

    Hi,

    I need to drive an input at a board which is connected to my board through samtec connectors at 200 Mhz, 1.8V, single ended. In cyclone 10 GX device, Which IO standard should I pick?

  2. #2
    Join Date
    Nov 2017
    Posts
    532
    Rep Power
    1

    Default Re: Which IO standard needs to be used? 200 MHz 1.8 V

    Hi,

    Is 200 Mhz, 1.8V are maximum rating what connector can withstand?

    You can use 1.5-V LVCMOS and 1.8-V LVTTL/LVCMOS.
    Refer Cyclone Handbook Volume 1.

    Best Regards,
    Anand Raj Shankar
    (This message was posted on behalf of Intel Corporation

Similar Threads

  1. standard DE2_70
    By tassou in forum Embedded Design Suite (EDS)
    Replies: 0
    Last Post: November 9th, 2013, 07:16 AM
  2. I/O standard:Different between 3.3V and 2.5V
    By hxdzjk in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 7
    Last Post: February 15th, 2011, 08:10 AM
  3. PCI IO Standard on the Row IO of EP2SGX90
    By linyifan in forum General Altera Discussion
    Replies: 0
    Last Post: November 7th, 2010, 06:06 PM
  4. Standard IO in the Nios II ISS
    By spargopolis in forum General Software Forum
    Replies: 0
    Last Post: January 12th, 2010, 05:32 PM
  5. usb 1.1 standard
    By vass in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 0
    Last Post: July 2nd, 2009, 01:15 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •