Results 1 to 2 of 2

Thread: MAX10: USB Blaster uploads to flash or SRAM?

  1. #1
    Join Date
    Dec 2017
    Posts
    8
    Rep Power
    1

    Default MAX10: USB Blaster uploads to flash or SRAM?

    I never worked with MAX, so i'm not sure where USB Blaster uploads the bitstream for debugging? In other words will it wear the internal flash while developing and upload the cores?

  2. #2
    Join Date
    Feb 2018
    Posts
    142
    Rep Power
    1

    Default Re: MAX10: USB Blaster uploads to flash or SRAM?

    Hi,
    1. In JTAG configuration: It will directly program the CRAM
    2. In Internal configuration: Here you first need to program the configuration flash memory (CFM) with .pof file & then during internal configuration Intel MAX 10 devices load the CRAM with configuration data from the CFM.
    I think internal flash might available by default in Quartus tool. Even you can use the on-chip Flash Intel FPGA IP core to access flash in the Intel Quartus tool.
    Refer following Configuration user guide,
    https://www.altera.com/en_US/pdfs/li...m10_config.pdf

    Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

    Best Regards
    Vikas Jathar
    (This message was posted on behalf of Intel Corporation)
    Last edited by jatharvk; July 4th, 2018 at 06:04 PM.

Similar Threads

  1. USB Blaster 2 + MAX10 - TCK / programming issue
    By PeterPan86 in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 3
    Last Post: October 4th, 2016, 07:02 AM
  2. Downloading on the custom MAX10 board with USB Blaster
    By barneta in forum General Altera Discussion
    Replies: 1
    Last Post: March 4th, 2016, 02:51 AM
  3. can max10 use outside flash as configure flash?
    By qd0090 in forum General Discussion Forum
    Replies: 4
    Last Post: January 4th, 2016, 11:33 PM
  4. Replies: 3
    Last Post: November 9th, 2009, 10:28 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •