Results 1 to 2 of 2

Thread: Cyclone V ASx4 configuration

  1. #1
    Join Date
    Apr 2018
    Rep Power

    Default Cyclone V ASx4 configuration

    I've got a Terasic Cyclone V GX development board. I removed the EPCQ256 configuration device and am testing another alternative (Micron MT25QL256ABA). I created a simple project with LEDS and "generic_quad_spi_controlelr2" and am using JTAG indirect programming to program the device (jic file).

    Quartus (17.1) will program the device without error. When I created the jic in "Active serial" mode it is able to boot but in "Active Serial x4" it isn't.

    Any thoughts?

  2. #2
    Join Date
    Feb 2018
    Rep Power

    Default Re: Cyclone V ASx4 configuration

    Although you are using the Quartus Prime software version 17.1, Can you check once by setting the non-volatile configuration register from the following link for ASx4?

    Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

    Best Regards
    Vikas Jathar
    Intel Customer Support Engineering
    (Under Contract to Intel)

Similar Threads

  1. 3rd party boot flash memory in ASx4
    By YoavKazt in forum General Altera Discussion
    Replies: 4
    Last Post: February 7th, 2018, 06:34 PM
  2. Cyclone IV E Configuration with Enhanced Configuration Devices
    By shauk in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 3
    Last Post: August 16th, 2017, 06:16 AM
  3. [Configuration Related] Cyclone III AP Configuration
    By mohsin_qau in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 12
    Last Post: March 22nd, 2016, 03:14 AM
  4. Cyclone III Configuration
    By richas in forum FPGA, Hardcopy, and CPLD Discussion
    Replies: 5
    Last Post: April 16th, 2013, 12:02 PM
  5. Replies: 1
    Last Post: May 29th, 2012, 03:04 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts