Results 1 to 4 of 4

Thread: Good editor for OpenCL in linux (.cl files)

  1. #1
    Join Date
    May 2018
    Posts
    12
    Rep Power
    1

    Default Good editor for OpenCL in linux (.cl files)

    I have tried installing the opencl extensions for visual code and eclipse. They do not work. Any suggestions from your side?

  2. #2
    Join Date
    May 2018
    Posts
    6
    Rep Power
    1

    Default Re: Good editor for OpenCL in linux (.cl files)

    What do you mean they do not work? I use the VS Code OpenCL plugin and it highlights the syntax just fine.

  3. #3
    Join Date
    May 2018
    Posts
    12
    Rep Power
    1

    Default Re: Good editor for OpenCL in linux (.cl files)

    I have tried using the editor you have mentioned. I have enabled the plugin. I dont see the kernel code highlighted. I have attached VS code window. I am currently using linux.
    Attached Images Attached Images

  4. #4
    Join Date
    May 2018
    Posts
    6
    Rep Power
    1

    Default Re: Good editor for OpenCL in linux (.cl files)

    I cannot real see what extension that is because of the low resolution image, but this is the one I installed: https://marketplace.visualstudio.com....vscode-opencl

    Don't forget to reload your VS Code client after installation. I have VS Code 1.23.0 btw. And the plugin version 0.2.1

Similar Threads

  1. verilog header files in Qsys component editor
    By rod@ariradesign.com in forum Quartus II and EDA Tools Discussion
    Replies: 1
    Last Post: August 18th, 2017, 04:13 PM
  2. Good tutorials beginner opencl
    By m.hgras in forum OpenCL
    Replies: 1
    Last Post: July 24th, 2015, 08:15 AM
  3. Is SoC EDS web version only good for linux?
    By Rodo in forum SoC Development Kits
    Replies: 0
    Last Post: March 26th, 2014, 08:19 AM
  4. OpenCL 13.0 SP1 Output RBF Files
    By snth in forum OpenCL
    Replies: 1
    Last Post: September 3rd, 2013, 10:13 AM
  5. sopc component editor and tcl files
    By smartfusion in forum General Altera Discussion
    Replies: 10
    Last Post: March 18th, 2013, 10:07 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •